![]() I believe what I still have to do is 3 or N point align using EQMOD and then use stellarium to GOTO. I have left it tracking for over an hour and all looks pretty good. The mount then slews to the sun (pretty accurately) and on EQMOD select Solar track. Connect also Stellarium Scope.ĥ Using Stellarium select Sun (Scope is not on the mount) and press ctrl +1 Plug in RS232 cable to SynScan.ģ Make sure EQMOD and stellarium all have the same lat and longĤ Connect EQMOD and connect. What I did wasġ Align mount to point North and balance it. Stellarium ONLY slews the mount you cannot align Stellarium. What I use is EQ5 Synscan and installed EQMOd and Stellarium Scope. Once you have the software configured correctly, you should be able to successfully connect to the PMC-Eight and navigate the sky using Stellarium.Simon I have over the past 2 weeks been playing with stellarium and the scope mounts. It is suggested that you use the ASCOM Platform Program POTH if you are going to use multiple ASCOM clients at the same time, programs such as PHD2, and Sequence Generator Pro (SGP). Refer to the instructions included with Stellarium an StellariumScope for the details. ![]() Once you start up Stellarium, you can start up StellariumScope and configure the ASCOM chooser and select the Explore Scientific PMC-Eight ASCOM Telescope driver. You need to download and install the StellariumScope program after installing the ASCOM platform software and the PMC-Eight ASCOM Driver. The Stellarium program uses an additional program called StellariumScope to interface the PMC-Eight ASCOM driver to the Stellarium program. Once you have done that, then you need to download and configure the ASCOM Driver and configure it for your location and setup. You need to download and install the program StellariumScope.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |